 |
 |
 |
|
|
|
[Sponsors] | ||||
July 6, 2004, 20:26
|
Gap produced in sliding mesh method
|
#1 |
|
Guest
Posts: n/a
|
In applying the sliding mesh method at propeller flow prediction, the solid propeller will be wrapped by the fluid to form a rotor. Instead of rotate the embeded propeller, we rotate the entire rotor.
Should I minimise the gap between the propeller tip and rotor edge to reduce the inconsistency of the virtual rotating and the physical rotating? |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Polyhedra and sliding mesh? | rockewan | FLUENT | 5 | December 1, 2018 20:07 |
| Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
| sliding mesh, confused me, help! help！ | weiyang1980 | FLUENT | 2 | September 30, 2009 22:45 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
Linear Mode
