|
[Sponsors] |
July 8, 2004, 02:13 |
Problem in giving heat source
|
#1 |
Guest
Posts: n/a
|
Haai, For my geometry, for a voulme (3d) I am giving heat source value. When I am giving that value it is showing following message.
Error: GENERAL-CAR-CDR: invalid argument [1]: improper list Error Object: #f For some cases it worked successfully, but after that it is started giving problem. If any body knows about it please tell me about this problem, because for this reason only my project has been stopped. I tried with different version of Fluent. Thank you |
|
July 10, 2004, 17:54 |
Re: Problem in giving heat source
|
#2 |
Guest
Posts: n/a
|
Are you applying source on one of the volumes in 3D model??? Try with small problem and check if it works fine... If it doesn't work with a small tutorial type of problem... then your fluent may have some issue...
AJ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
source terms-convergence problem | alanlove | FLUENT | 0 | March 28, 2010 06:47 |
Missing heat source | Phil | FloEFD, FloWorks & FloTHERM | 9 | June 19, 2008 10:33 |
Heat source problem | ocy | FLUENT | 7 | February 17, 2005 02:08 |
Heat Generation as time dependent problem | Denis Kadito | FLUENT | 0 | April 17, 2001 16:28 |
UDFs for Scalar Eqn - Fluid/Solid HT | Greg Perkins | FLUENT | 0 | October 11, 2000 03:43 |