CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Pond Boundary Conditions

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   August 24, 2004, 19:03
Default Pond Boundary Conditions
  #1
J.W.
Guest
 
Posts: n/a
Hello,

I am simulating the process of pumping slurry into the pond where sand, clay and water were stored. I am going to using Multiphase (Euler-Euler) Model. But I can not get converged result due to boundary conditions. Since the slurry was pumped into the pond and level of the slurry will increase, which outlet boundary condition can I set for the surface of the pond (excluding the area used for velocity inlet)?

Thanks,

J.W.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Impinging Jet Boundary Conditions Anindya Main CFD Forum 25 February 27, 2016 13:58
symmetry boundary conditions in cfx lost.identity CFX 41 May 22, 2013 08:21
Boundary conditions for 2D Navie-Stockes simulation L1011 OpenFOAM 5 December 13, 2012 09:17
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues michele OpenFOAM Meshing & Mesh Conversion 2 July 15, 2005 05:15
A problem about setting boundary conditions lyang Main CFD Forum 0 September 19, 1999 19:29


All times are GMT -4. The time now is 16:26.