Home > Forums > Software User Forums > ANSYS > FLUENT

how to select surface by commands

Mark Forums Read

Reply

Search this Thread

September 18, 2004, 10:47	how to select surface by commands	#1
venugopal Guest Posts: n/a	Hi, Anybody know how to select a surface in 3-d geometry by using commands in fluent and not by GUI. Thanks in advance

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 12:12
Thermocapillary free surface flow	zakifoam	OpenFOAM Running, Solving & CFD	10	December 12, 2016 12:44
Surface Tension Test Cases	sega	OpenFOAM Running, Solving & CFD	2	March 8, 2011 13:19
Patran Volume Meshing	Deb	CFX	19	April 17, 2003 11:56
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 07:47

All times are GMT -4. The time now is 01:13.