 |
 |
 |
|
|
|
[Sponsors] | ||||
September 20, 2004, 06:16
|
boundary conditions
|
#1 |
|
Guest
Posts: n/a
|
Hello all
I am using dynamic mesh model which simulates the movement of shuttle due to pressure difference across either sides. But the problem is I declared the piston face as wall, where I am specifying the velocity. Also I need two walls(piston entry and exit faces where the pressure has to be measured). This difference in pressure is converted to velocity of piston. So I have to declare two boundary conditions to a particular edge. But Gambit is not allowing me to do that. Either of one is possible in it. Is it possible by anyway to declare 2 BC to a particular entity? Regards Karthick |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 13:58 |
| symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 08:21 |
| OpenFOAM Variable Velocity Boundary Conditions | NickolasPl | OpenFOAM Programming & Development | 2 | May 19, 2011 06:37 |
| [Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 10:38 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
