Home > Forums > Software User Forums > ANSYS > FLUENT

Porous Jump BC

Mark Forums Read

Reply

Search this Thread

October 28, 2004, 17:22	Porous Jump BC	#1
elmccoy Guest Posts: n/a	Hi, I'm modeling air being pumped through the walls of a porous tube where it will mix with air being pumped through the center of a porous tube. I'm modeling it in 2-d axisymmetrically. I was wondering, does the porous jump condition have to be specified as on an edge or do I need to create a face for it? Thanks a lot Eric

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] How can I define different zones in ICEM?	llrr	ANSYS Meshing & Geometry	14	February 12, 2017 13:44
[Commercial meshers] Porous Jump creation problem	mulfal	OpenFOAM Meshing & Mesh Conversion	4	December 9, 2013 11:59
Porous jump in urban environment	samygero	FLUENT	0	February 14, 2011 18:26
Porous Jump	Naresh	FLUENT	0	April 25, 2007 15:36
Testing the integrity of POROUS media and por jump	Azman	FLUENT	0	July 31, 2006 11:11

All times are GMT -4. The time now is 01:27.