 |
 |
 |
|
|
|
[Sponsors] | ||||
November 3, 2004, 19:16
|
simulate inner combustin engine
|
#1 |
|
Guest
Posts: n/a
|
hello everyone, i am simulating compressing process of inner combustion engine by the capability of dynamic mesh in fluent, i found that the convergence speed is very slow and the residual of continuty can not be reduced and interestingly the pressure in engine is not increased. would you give me some good advice?
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help:can I use fluent to simulate the intake stroke of IC engine | bright181 | FLUENT | 0 | January 9, 2011 21:09 |
| How to simulate combution process in a internal combution engine. | shiyan189 | FLUENT | 0 | April 23, 2010 14:11 |
| Can I simulate the internal combustion engine with OF? | fuvictor | OpenFOAM | 0 | October 27, 2009 21:40 |
| Simulate flow in and out of engine | guido_adriaensen | OpenFOAM Running, Solving & CFD | 0 | November 17, 2005 04:20 |
| Can Fluent be used to simulate IC engine flows? | Jimmy Fox | FLUENT | 1 | September 7, 2005 10:35 |
Linear Mode
