merge zones

November 4, 2004, 08:17

I tried to merge 2 wall zones using the merge zones panel. I got the following error message: " merge-threads: unable to merge selected threads". In the command panel fluent said that the zones didn't match. What does that mean? What did I do wrong? The zones I selected are of the same type (wall) so that couldn't be the problem, could it?

Onurozcan · February 21, 2016, 14:59

Quote:

Originally Posted by Domi
;115944

I tried to merge 2 wall zones using the merge zones panel. I got the following error message: " merge-threads: unable to merge selected threads". In the command panel fluent said that the zones didn't match. What does that mean? What did I do wrong? The zones I selected are of the same type (wall) so that couldn't be the problem, could it?

I would like to learn about it.But anyone know it as you see

Mazze[ITA] · May 3, 2019, 14:15

Quote:

Originally Posted by Domi
;115944

I tried to merge 2 wall zones using the merge zones panel. I got the following error message: " merge-threads: unable to merge selected threads". In the command panel fluent said that the zones didn't match. What does that mean? What did I do wrong? The zones I selected are of the same type (wall) so that couldn't be the problem, could it?

Have you tried to merge the cell zones before merging the boundary zones?

November 4, 2004, 08:17	merge zones	#1
Domi Guest Posts: n/a	I tried to merge 2 wall zones using the merge zones panel. I got the following error message: " merge-threads: unable to merge selected threads". In the command panel fluent said that the zones didn't match. What does that mean? What did I do wrong? The zones I selected are of the same type (wall) so that couldn't be the problem, could it?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
assemble the mesh	feixiangniao	ANSYS Meshing & Geometry	2	March 20, 2010 03:39
[mesh manipulation] Merge blockMesh and Gambit, failing at zones	kjetil	OpenFOAM Meshing & Mesh Conversion	0	December 7, 2009 09:52
about merge mesh	lian	Main CFD Forum	3	February 29, 2008 11:47
Require help in "Merging Grid Zones"	Nitesh Goyal	FLUENT	0	June 13, 2007 11:25
Patch-Different values to different zones	Pradeep	FLUENT	0	April 26, 2005 09:50