|
[Sponsors] |
November 10, 2004, 18:10 |
Grid Checking
|
#1 |
Guest
Posts: n/a
|
Hello all,
I have created a finite element volume in gambit to analyze flow around a sphere.. But when I import my mesh to Fluent and make a grid check it gives the following warning: "WARNING: Missing id, child 2 on face 4587 (t 11)".. that number 4587 starts from 1.. oh it annoys to wait for it to count.. |
|
November 10, 2004, 18:30 |
Re: Grid Checking
|
#2 |
Guest
Posts: n/a
|
I had similar problems with a grid generated with HEXCORE. However the calculation and the results were ok.
Hi ap |
|
November 11, 2004, 15:12 |
Re: Grid Checking
|
#3 |
Guest
Posts: n/a
|
then I should start solution.. I have waited to fix the problem, however I couldn't find any solution..
|
|
November 15, 2004, 03:47 |
Re: Grid Checking
|
#4 |
Guest
Posts: n/a
|
try to mesh again with but try this time mesh should be coarse so that u can analyse where u need refined mesh and also u get idea of solution
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
OpenFOAM installation problem on Linux 32bit | kumar | OpenFOAM Installation | 0 | April 27, 2007 05:41 |
Help%7e%7einstall openfoam13 on fc5%7e%7e | aderliner | OpenFOAM Installation | 2 | September 11, 2006 07:24 |
Gerris software installation | mer | Main CFD Forum | 2 | November 12, 2005 08:50 |