|
[Sponsors] |
November 18, 2004, 01:29 |
Pipe flow !
|
#1 |
Guest
Posts: n/a
|
Friends, I am simulating a 3d flow in a circular pipe, which is inclined at an angle of 15 degrees below the x-axis. When I see the cartesian x-velocity vectors, after having got the converged solution, I notice the vectors are in one direction (in positive x direction). But when I look at the axial velocity vectors (in cylidrical system) I see vectors both in positive and neagitve x directions. Is this correct ? If it is correct is it because of the secodary flows ? Let me know.
A beginer |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LES transitional pipe entrance flow | hasanduz | Main CFD Forum | 2 | October 11, 2013 17:59 |
HTC in Pipe flow | subsemitonium | CFX | 6 | May 6, 2013 22:00 |
[GAMBIT] meshing in GAMBIT, a flow through a pipe having complex inflow geometry | mazhar1613 | ANSYS Meshing & Geometry | 1 | January 11, 2012 23:18 |
[ASK] Flow in Corrugated Pipe with FLUENT | Primadhani | FLUENT | 1 | May 11, 2011 20:41 |
Pipe Flow | Saima | CFX | 1 | January 10, 2011 16:41 |