 |
 |
 |
|
|
|
[Sponsors] | ||||
December 14, 2004, 07:43
|
Cooper Scheme
|
#1 |
|
Guest
Posts: n/a
|
All,
I am having problems with using the Cooper mesh scheme in Gambit. I am attempting to solve a short pipe turbulence problem with fine resolution boundary layer using the periodic boundary condition in order to get a fully developed profile. Obviously I need to hard link the two boundaries but this means the Cooper meshing scheme does not work. Any ideas? Thanks in advance Sandy Lawson |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Constant value by Cooper scheme | Mohsin | FLUENT | 0 | August 21, 2011 22:14 |
| Cooper Scheme Question (w/pics) | Forrest | ANSYS Meshing & Geometry | 2 | March 26, 2009 16:19 |
| IMPRINT COMMAND IN COOPER MESHING SCHEME | TINA | FLUENT | 3 | October 7, 2006 06:03 |
| GAMBIT - Cooper Scheme | JB | FLUENT | 4 | February 17, 2005 09:32 |
| Error message on Cooper scheme mesh | Mnu & Luc | FLUENT | 1 | January 20, 2003 06:56 |
Linear Mode
