 |
 |
 |
|
|
|
[Sponsors] | ||||
December 24, 2004, 10:55
|
Gambit problem
|
#1 |
|
Guest
Posts: n/a
|
I'm having problems with a mesh I'm building in Gambit.
Has anyone had problems when copying a volume with a mesh and the copied mesh has inverted elements? The first mesh is fine (max skewness ~ 0.7 and about 35,000 elements) but the copied one went nuts ( >200 inverted elements, and none of the meshes on the new faces line up properly). The same problem happens whether I copy the volume using a translation, a rotation, or a reflection of the volume. Has anyone seen this problem before, and if so, how did you get around it? I appreciate any help! Thanks, Jason |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit geometry problem | cestrin | FLUENT | 3 | July 4, 2012 02:33 |
| [Commercial meshers] Problem with Mesh conversion Gambit msh Foam | Rachid BANNARI (Bannari) | OpenFOAM Meshing & Mesh Conversion | 25 | September 11, 2011 07:58 |
| Gambit installation problem | Panos | FLUENT | 4 | March 5, 2009 22:44 |
| Problem meshing with Gambit | Adrian | FLUENT | 8 | October 7, 2008 08:39 |
| Startup Problem in Gambit 2.2 with WindowXP | Win Win Maw | FLUENT | 3 | January 25, 2006 11:09 |
Linear Mode
