Home > Forums > Software User Forums > ANSYS > FLUENT

how to specify a mechanism in a geometrical zone ?

Mark Forums Read

Reply

Search this Thread

January 5, 2005, 11:30	how to specify a mechanism in a geometrical zone ?	#1
Ionut Guest Posts: n/a	Hi, I am trying to modelise a plasma reactor used for SiOx deposition but in Fluent I cannot specify the geometrical zone where the reactions take effect. Thank you!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Fluent3DMeshToFoam	simvun	OpenFOAM Meshing & Mesh Conversion	50	January 19, 2020 16:33
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 18:51
Problem in IMPORT of ICEM input file in FLUENT	csvirume	FLUENT	2	September 9, 2009 02:08
Error to re-open fluent case file	J.Gimbun	FLUENT	0	April 27, 2006 09:42
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 16:52

All times are GMT -4. The time now is 21:47.