|
[Sponsors] |
January 6, 2005, 12:09 |
Error Abortiom in Fluent
|
#1 |
Guest
Posts: n/a
|
i used software Gambit tp construct a model of dump bell shape. after saving, i converted it to mesh format and then read it from Fluent 6.
but it shows that there was error. the error was no cells in zone, id = 0, ind1 = 1, indn = 0Reading cellsL failed while reading section 12. clearing partially read grid. it seems to be a critical error. as i already meshed the whole 3-D shape. so what go wrong and how can i know where is thezone of id = 0 ? thanks |
|
January 7, 2005, 03:13 |
Re: Error Abortiom in Fluent
|
#2 |
Guest
Posts: n/a
|
"after saving, i converted it to mesh format " ,, did you export the mesh to fluent format??? (file->export->fluent)
|
|
January 10, 2005, 03:03 |
Re: Error Abortiom in Fluent
|
#3 |
Guest
Posts: n/a
|
yes,
i convert it to Fluent format |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 05:16 |
A Problem of Fluent Interpreted UDF: parse error | knight | Fluent UDF and Scheme Programming | 25 | August 16, 2018 11:26 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 04:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 07:24 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 17:48 |