 |
 |
 |
|
|
|
[Sponsors] | ||||
January 7, 2005, 03:50
|
RE: PC cofiguration for 3-D simulation
|
#1 |
|
Guest
Posts: n/a
|
Hi, I am simulating 3-D column with 300,000 cell volumes. I am going to buy a PC: Pentium 3 Ghz Processor, 1 GB memory 400 MHz, and 80 HD 7200 rpm. Are these configuration good enough to run my 3-D column with 300,000 cell volumes. Please advice. Thanks in advance.
Lee |
|
|
||
|
January 7, 2005, 04:22
|
Re: RE: PC cofiguration for 3-D simulation
|
#2 |
|
Guest
Posts: n/a
|
Ok for your problem size. Should be able to tackle 500,000 cells too with this config.
|
|
|
|
||
|
January 7, 2005, 14:32
|
Re: RE: PC cofiguration for 3-D simulation
|
#3 |
|
Guest
Posts: n/a
|
Thank you very much anindya
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 04:36 |
| Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 05:43 |
| Axial fan simulation in UG/NX 7.5 | fan123 | Main CFD Forum | 2 | April 23, 2011 09:22 |
| Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 11:44 |
| strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 14:02 |
Linear Mode
