Home > Forums > Software User Forums > ANSYS > FLUENT

How to model different liquid in a hot bath

Mark Forums Read

Reply

Search this Thread

January 11, 2005, 20:16	How to model different liquid in a hot bath	#1
Patel Amit Guest Posts: n/a	Respected sir: How to model different fluid (of different density), in a single bath and setting combustion model outside the bath. i.e. to different liquid is placed in a single bath which is heated from out side, how to model the same. Fluent is showing the patch can not be used with the combustion model. is there any way out. Thanx

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Evaporation model in ansys Fluent 12.1	oldisbest	Fluent UDF and Scheme Programming	12	March 26, 2020 09:11
Liquid rocket engine non-premixed combustion model	Erik	FLUENT	2	November 28, 2013 14:09
2 stage axial turbine model convergence issues	sherifkadry	CFX	2	September 7, 2009 20:51
Questions about Cross-Arrhenius and Cross-WLF viscosity model	awacs	OpenFOAM Running, Solving & CFD	4	August 13, 2009 06:56
DPM model w/ Wave model - errors in documentation	HS	FLUENT	0	April 12, 2006 04:37

All times are GMT -4. The time now is 03:26.