Home > Forums > Software User Forums > ANSYS > FLUENT

Some problem about surface injection

Mark Forums Read

Reply

Search this Thread

February 22, 2005, 21:29	Some problem about surface injection	#1
Jenny Guest Posts: n/a	There are some parameters need to be specified in surface injection, but I do not really understand their meaning. Can some one help me? Min. Diameter Max. Diameter Mean Diameter How to specify these three parameters? Just based on the experiment?? Spread parameter Number of Diameter I don't understand the meaning of these two parameters. Thanks for explanation. Jen

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Patch dependent surface mesh problem!	hadikhayyamian	ANSYS Meshing & Geometry	14	January 27, 2018 08:47
Problem Concerning free surface wave simulation	michaels	STAR-CCM+	3	February 25, 2011 07:28
Problem with capturing water-spreading for free surface flow	devesh.baghel	OpenFOAM	2	December 10, 2009 01:21
Hollow Cone Injection Problem	JaC	FLUENT	1	December 3, 2009 03:03
Surface orentation problem in icemcfd	jeevan kumar	CFX	0	August 13, 2008 01:54

All times are GMT -4. The time now is 13:07.