 |
 |
 |
|
|
|
[Sponsors] | ||||
March 7, 2005, 07:50
|
Errors in Gambit befor exit
|
#1 |
|
Guest
Posts: n/a
|
Dear colleagues befor exit from Gambit I has made the following: in "Solver" I has put "Fluent 5/6", then has gone in "Specify boundary types" and then I try to export mesh. But the mistake "Continuum or Boundary condition specified on entity edge ... is invalid for fluent 6". What I must do? Such mistake befor was not.
|
|
|
||
|
March 7, 2005, 08:06
|
Re: Errors in Gambit befor exit
|
#2 |
|
Guest
Posts: n/a
|
I would say that your mesh is 2D and you forgot to mark the box "export 2d mesh".
Hope this helps. Jason |
|
|
|
||
|
March 7, 2005, 08:56
|
Re: Errors in Gambit befor exit
|
#3 |
|
Guest
Posts: n/a
|
Thank you Mr. Jason!!! You are right!!!
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
Linear Mode
