divergence detect in AMG
Hi everyone
Some error occured in my simulation when I add mass source to two phase flow. After the sources were added the solver give the follow info: divergence detect in AMG: pressure correction. I don't what it means. Anyone can give some help BR Erica |
Re: divergence detect in AMG
I am getting the similar thing in my simulation Did you correctly specify the source term both A and B part? Decrese the urf this might help you. Z
|
Re: divergence detect in AMG
I encountered the same problem. I think you should check your BC.
|
Re: divergence detect in AMG
Check your source term and verify if its dimensions are right. Remember you have to refer it to the unit volume.
Best regards, ap |
Re: divergence detect in AMG
Thank you!
BR Erica |
All times are GMT -4. The time now is 08:41. |