Hi everyone

Some error occured in my simulation when I add mass source to two phase flow. After the sources were added the solver give the follow info: divergence detect in AMG: pressure correction. I don't what it means. Anyone can give some help

BR

Erica

I am getting the similar thing in my simulation Did you correctly specify the source term both A and B part? Decrese the urf this might help you. Z

I encountered the same problem. I think you should check your BC.

Check your source term and verify if its dimensions are right. Remember you have to refer it to the unit volume.

Best regards, ap

Thank you!

BR

Erica