|
[Sponsors] |
April 5, 2005, 23:37 |
flow rate of scalar ...
|
#1 |
Guest
Posts: n/a
|
Hi,
I am trying to monitor the flow rate of a scalar through an interior boundary. I used monitor->surface->flow rate of UDS. However, by any reason I couldn't get the right flow rate. Everything in the simulation (mesh, definition of diffusivity, turbulence modeling, trasport of scalar, etc.) seems OK. Does any of you face with similar problem before? Any help will be appreciated. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dieselFoam problem!! trying to introduce a new heat transfer model | vivek070176 | OpenFOAM Programming & Development | 10 | December 23, 2014 23:48 |
Mass Flow Rate Error | jallison | FLUENT | 1 | May 16, 2011 16:22 |
Mass flow rate | Neser | CFX | 4 | February 14, 2004 00:27 |
Determine mass flow rate along flow path | Atit Koonsrisuk | CFX | 2 | October 5, 2003 04:47 |
mass flow inlet | Denis Tschumperle | FLUENT | 7 | August 9, 2000 02:19 |