Home > Forums > Software User Forums > ANSYS > FLUENT

Erosion

Mark Forums Read

Reply

Search this Thread

April 12, 2005, 08:10	Erosion	#1
shhe Guest Posts: n/a	Hi I am working to track a particle in cyclone. I have already gotten good results with the fluid phase. I hav ea problem in tracking. I have activated Diuscrete phase particle with the fluid. I am tracking about 2255 particles from the inlet surface. In postprocessing process (desplay > contours > DPM > erosion all are zero at all domains Further, all variables to DPM are zero What can I do?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
erosion in pipe's elbow simulation	Fluid Engineer	FLUENT	1	December 4, 2010 07:32
Erosion Rate	dcw	CFX	0	August 27, 2008 16:50
URGENT QUESTION ABOUT DPM EROSION!!!!!!	alex	FLUENT	2	October 28, 2005 07:33
Erosion Model	Brian	FLUENT	0	December 10, 2003 08:32
Erosion problem	Ko	Siemens	2	September 24, 2003 08:48

All times are GMT -4. The time now is 09:22.