Home > Forums > Software User Forums > ANSYS > FLUENT

help: plane in 2.5D model

Mark Forums Read

Reply

Search this Thread

April 21, 2005, 22:32	help: plane in 2.5D model	#1
Dorain Guest Posts: n/a	I want to simulating a pump in FLUENT with 2.5D model. but when i iterate it, the warning prompt. Warning: Geometry of zone 4 isn't defined as plane. Assuming plane for extrusion. how to set a plane? Thank you very much. best regards, dorain

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
multiphaseInterFoam for RAS turbulence model	chiven	OpenFOAM Bugs	8	December 6, 2017 02:08
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
2 stage axial turbine model convergence issues	sherifkadry	CFX	2	September 7, 2009 20:51
multi fluid mixture model issue	rystokes	CFX	3	August 9, 2009 19:13
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model	Jonas Larsson	FLUENT	5	March 13, 2000 03:27

All times are GMT -4. The time now is 13:34.