|
[Sponsors] |
set boundary condition in Neutral file, in Gambit |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 25, 2005, 23:40 |
set boundary condition in Neutral file, in Gambit
|
#1 |
Guest
Posts: n/a
|
In Gambit, when setting "Solver->Generic" so as to export Neutral file, there are only two boundary condition types, ELEMENT SIDE & NODE. Anybody know how to introduce other BC types, such as , wall/mass flow inlet when exporting Neu file? (not *.msh). Any help will be appreciated!
|
|
April 26, 2005, 06:43 |
Re: set boundary condition in Neutral file, in Gam
|
#2 |
Guest
Posts: n/a
|
Dear Vito: You can not set your proposed boudary condition in gambit. You can simply set differt boundary condition names in gambit and then change it to appropriate type in fluent.(you can change all boundary condition types in fluent but not names)
|
|
April 26, 2005, 06:50 |
Re: set boundary condition in Neutral file, in Gam
|
#3 |
Guest
Posts: n/a
|
As I remember, with the neutral format you could only export the mesh not the boundary conditions.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |
Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 06:43 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
PHI file structure | Eugene | Phoenics | 9 | November 2, 2001 22:00 |