|
[Sponsors] |
April 26, 2005, 04:38 |
sliding mesh
|
#1 |
Guest
Posts: n/a
|
hi all,
i am simulating a moving ship using sliding mesh with VOF. i am subtracting ship from my domain and after meshing the ship and domain seperate, i merged both the mesh using tmerge. But the problem is when i am exporting the above mesh to fluent, Grid check fails and it says non positive volume exists. can any one help me. can you suggest any other strategy and the way of setting up the above probelm thanks |
|
April 26, 2005, 15:30 |
Re: sliding mesh
|
#2 |
Guest
Posts: n/a
|
You can use dynamic meshing. Its easy.
CFDtoy |
|
April 27, 2005, 03:20 |
Re: sliding mesh
|
#3 |
Guest
Posts: n/a
|
for using sliding mesh, when we name innerzone (which is goign to move) as something and then when we read the mesh, fluent usually fails grid check after defining the interface,
i have reported this to fluent support but i haven't got any satisfactory answer. for my calculations though i have found out a way to go around it, the thing is , what i do is i complete the mesh assuming that the faces on sliding interface are connected, that is they have same mesh distribution, finally after this when i define the interfaces on them and use it fluent never fails th egrid check. hope it works |
|
April 27, 2005, 06:55 |
Re: sliding mesh
|
#4 |
Guest
Posts: n/a
|
hi
i am getting one more error, "unassigned interface zones" , when i am changing the interface from wall tointerface BC whats the probelem |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
Sliding mesh error | alice | FLUENT | 3 | February 21, 2012 05:53 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
dynamic mesh and sliding mesh | nasser | FLUENT | 0 | November 1, 2005 02:37 |