|
[Sponsors] |
April 28, 2005, 06:59 |
have problem with porous modeling
|
#1 |
Guest
Posts: n/a
|
hi i want to model a Heat pipe that has porous wick in fluent.i used VOF model for two phase model but my vapor insted of liquid moves on porous wick . i want to know if i change some parameteres like Viscuse and Inertial resistance or Power low model parameters such C0 , C1 it workd good or not ? and anybody knows something regard these parameters.
wishes, M.Ghanaei |
|
May 18, 2005, 02:42 |
Re: have problem with porous modeling
|
#2 |
Guest
Posts: n/a
|
Hello please i want to calculate resistance for porous media (c2 in fluent) but in the Van Winkle formulation I can not calculate c(the coffecient tabulated by reynolds &...) please I want to have this table for c also Is it possible to use porous media for modeling the electrofilter guide plate
|
|
May 23, 2005, 13:52 |
Re: have problem with porous modeling
|
#3 |
Guest
Posts: n/a
|
You will find your C coeffcient in the perry's handbook, look for "perforate plate"
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure drag problem in porous media with interFoam | skp | OpenFOAM Running, Solving & CFD | 8 | May 27, 2015 08:10 |
Problem with rhoPorousMRFSimpleFoam and how to define porous media | Amit Mathur | OpenFOAM | 6 | July 18, 2013 06:57 |
problem about porous media and surface reaction | Jeff Lee | FLUENT | 3 | November 24, 2011 13:46 |
Membrane porous jump problem in VOF | Hema kothimbare | FLUENT | 0 | August 7, 2009 01:22 |
porous domain problem | sudhakar | CFX | 6 | November 29, 2006 09:48 |