CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Target Mass Flow Rate (

Tang May 12, 2005 16:14

Target Mass Flow Rate
Has any one had a problem with the target mass flow rate being printed during iterations using 6.2.16 on a LINUX OS? My verbosity is set to yes, but none of my target mass flow rates are being printed.

Luca May 13, 2005 02:55

Re: Target Mass Flow Rate
Are you sure you have changed your pressure-outlet to target-mass-flow from the TUI? Maybe you have enable the target-mass-flow but you haven't made it work.Luca

Tang May 13, 2005 11:56

Re: Target Mass Flow Rate
That's what I did in 6.1.25, but in 6.2.16 it is in the GUI of the pressure outlet boundary condition and when I switched versions all transfered correctly, so this is not the problem. Also, I have checked my mass flows at the outlets and they are correct. I am talking to fluent support now and they are trying to see what is wrong.

All times are GMT -4. The time now is 16:25.