 |
 |
 |
|
|
|
[Sponsors] | ||||
May 12, 2005, 16:14
|
Target Mass Flow Rate
|
#1 |
|
Guest
Posts: n/a
|
Has any one had a problem with the target mass flow rate being printed during iterations using 6.2.16 on a LINUX OS? My verbosity is set to yes, but none of my target mass flow rates are being printed.
|
|
|
||
|
May 13, 2005, 02:55
|
Re: Target Mass Flow Rate
|
#2 |
|
Guest
Posts: n/a
|
Are you sure you have changed your pressure-outlet to target-mass-flow from the TUI? Maybe you have enable the target-mass-flow but you haven't made it work.Luca
|
|
|
|
||
|
May 13, 2005, 11:56
|
Re: Target Mass Flow Rate
|
#3 |
|
Guest
Posts: n/a
|
That's what I did in 6.1.25, but in 6.2.16 it is in the GUI of the pressure outlet boundary condition and when I switched versions all transfered correctly, so this is not the problem. Also, I have checked my mass flows at the outlets and they are correct. I am talking to fluent support now and they are trying to see what is wrong.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF to measure Mass Flow Rate | a.lynchy | Fluent UDF and Scheme Programming | 31 | October 4, 2018 14:10 |
| CFX turbo - Mass flow rate | Vashishth Patel | CFX | 7 | April 3, 2014 20:33 |
| Regarding Target Mass Flow Rate | Ravinder Yerram | FLUENT | 3 | October 22, 2011 07:05 |
| mass flow rate error | Masood | FLUENT | 0 | May 22, 2005 00:32 |
| Target mass flow rate | Saturn | FLUENT | 0 | December 10, 2004 04:18 |
Linear Mode
