 |
 |
 |
|
|
|
[Sponsors] | ||||
April 28, 2005, 06:59
|
have problem with porous modeling
|
#1 |
|
Guest
Posts: n/a
|
hi i want to model a Heat pipe that has porous wick in fluent.i used VOF model for two phase model but my vapor insted of liquid moves on porous wick . i want to know if i change some parameteres like Viscuse and Inertial resistance or Power low model parameters such C0 , C1 it workd good or not ? and anybody knows something regard these parameters.
wishes, M.Ghanaei |
|
|
||
|
May 18, 2005, 02:42
|
Re: have problem with porous modeling
|
#2 |
|
Guest
Posts: n/a
|
Hello please i want to calculate resistance for porous media (c2 in fluent) but in the Van Winkle formulation I can not calculate c(the coffecient tabulated by reynolds &...) please I want to have this table for c also Is it possible to use porous media for modeling the electrofilter guide plate
|
|
|
|
||
|
May 23, 2005, 13:52
|
Re: have problem with porous modeling
|
#3 |
|
Guest
Posts: n/a
|
You will find your C coeffcient in the perry's handbook, look for "perforate plate"
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure drag problem in porous media with interFoam | skp | OpenFOAM Running, Solving & CFD | 8 | May 27, 2015 08:10 |
| Problem with rhoPorousMRFSimpleFoam and how to define porous media | Amit Mathur | OpenFOAM | 6 | July 18, 2013 06:57 |
| problem about porous media and surface reaction | Jeff Lee | FLUENT | 3 | November 24, 2011 13:46 |
| Membrane porous jump problem in VOF | Hema kothimbare | FLUENT | 0 | August 7, 2009 01:22 |
| porous domain problem | sudhakar | CFX | 6 | November 29, 2006 09:48 |
Linear Mode
