|
[Sponsors] |
June 3, 2005, 04:32 |
On the velocity inlet boundary condition
|
#1 |
Guest
Posts: n/a
|
Hi, how should I set the ¡°Outflow Gauge Pressure¡±value when I use ¡°velocity inlet boundary conditions¡± (Coupled Solver) for the unsteady simulation? Thanks.
|
|
June 3, 2005, 12:07 |
Re: On the velocity inlet boundary condition
|
#2 |
Guest
Posts: n/a
|
I don't think you can set the outflow guage pressure when you are using the velocity inlet boundary condition. You can give only one of them at a particular boundary.
Saad |
|
June 5, 2005, 20:50 |
Re: On the velocity inlet boundary condition
|
#3 |
Guest
Posts: n/a
|
Thanks. But,do you mean I should keep the outflow Gauge Pressure "0" on the velocity inlet panel? Will this affect the unsteady results? (I have set the unsteady inlet boundary conditions)
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
velocity profile inlet boundary condition question | Lcw | FLUENT | 3 | August 3, 2012 05:53 |
inlet boundary condition | swe704 | FLUENT | 4 | June 3, 2009 16:58 |
Inlet boundary condition | jkwan | FLUENT | 1 | August 5, 2008 21:22 |
mass flow inlet boundary condition | vivian | FLUENT | 5 | April 21, 2006 06:23 |