hi I have a problem with meshing this geometry: http://www.flickr.com/photos/ken22

The main problem is in the small corner where the inclined section merges with the flat surface. As I can't do a mapping throughout the flat part, I ended up using TGrid at that corner. Is there a way to make a better mesh using mostly rectangles?

zip the jou trn and dbs files in one folder (before doing this please remove the mesh from inside) and send it to me, i think i would be able to mesh it, let me try.

Let me try it,just send me the dbs, jou and trn files.

Try the Quad Map Tri-Primitive scheme.

It works great for using Quad mapping on wedges and triangular surfaces

hi, let me try send me the dbs, jou and trn file

Dear ken let me try too. send dbs and journal file.

i have modeled a model combuster chamber in gambit. i need to patch some surfaces. how to do it

I haven't got a viable solution yet. Pls drop me a note if you have any suggestions. Thanks.