 |
 |
 |
|
|
|
[Sponsors] | ||||
June 16, 2005, 15:50
|
volume meshin problem
|
#1 |
|
Guest
Posts: n/a
|
I am designing a cyclone separator. My solution diverges at the points where there is intersection of hex and tet meshing. I am not able to figure out the solution of this problem. Please help me in this. Thank you.
|
|
|
||
|
June 18, 2005, 07:34
|
Re: volume meshin problem
|
#2 |
|
Guest
Posts: n/a
|
You are using non-conformal hybrid mesh.Do you use interface between tow meshes? If yes, have you selected the smaller interface as interface_1?
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Zero Volume Fraction in Free Surface Problem | marega | CFX | 1 | September 10, 2009 07:31 |
| On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
| Volume mesh problem in STARDESIGN | Jaedal | Siemens | 2 | October 17, 2007 10:23 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
| volume mesh problem | Christophe | FLUENT | 9 | June 8, 2006 03:38 |
Linear Mode
