cyclic BC (diff. type) on the same wall
Hi,
I need to apply heat flux and convection B.C. on the same wall, one after another, and it will go on cycling. To be clear: say, heat flux (no convection) will be applied a certain wall for the first x time steps followed by convection for next y setps (when heat flux is zero or deactivated). It will go on like this...... I just have tried the "heat flux turn on/off" part using DEFINE_PROFILE and it worked fine. Now my question is - since this macro is hooked from the B.C. panel, where only one kind of B.C. can be activated at a time, will it work if I write two diff. DEFINE_PROFILE macros and hook them accordingly? Would DEFINE_ADJUST be a better solution? Thanks. - Hasan |
All times are GMT -4. The time now is 22:54. |