CFD Online Logo CFD Online URL
Home > Forums > FLUENT

cyclic BC (diff. type) on the same wall

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   July 2, 2005, 04:18
Default cyclic BC (diff. type) on the same wall
Posts: n/a

I need to apply heat flux and convection B.C. on the same wall, one after another, and it will go on cycling. To be clear: say, heat flux (no convection) will be applied a certain wall for the first x time steps followed by convection for next y setps (when heat flux is zero or deactivated). It will go on like this......

I just have tried the "heat flux turn on/off" part using DEFINE_PROFILE and it worked fine. Now my question is - since this macro is hooked from the B.C. panel, where only one kind of B.C. can be activated at a time, will it work if I write two diff. DEFINE_PROFILE macros and hook them accordingly? Would DEFINE_ADJUST be a better solution?


- Hasan

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 48 October 25, 2017 06:07
transsonic nozzle with rhoSimpleFoam Unseen OpenFOAM Running, Solving & CFD 7 April 16, 2014 03:38
Need help with boundary conditions: open to atmosphere Wolle OpenFOAM 2 April 11, 2011 07:32
buoyantSimpleRadiationFoam msarkar OpenFOAM 0 February 15, 2010 07:22
StarToFoam error Kart OpenFOAM Meshing & Mesh Conversion 1 February 4, 2010 05:38

All times are GMT -4. The time now is 12:45.