|
[Sponsors] |
August 3, 2005, 06:44 |
default interior
|
#1 |
Guest
Posts: n/a
|
dear all,
I am currently trying to model a 3-d wing in ground effect in wind tunnel conditions. I modelled the wing as half a wing then symmetry-ing it. In order to control the mesh, i divided the control volume into 2; a dense domain around the wing within another larger domain. However, i am having difficulty to get FLUENT to recognize the symmetry plane of the larger domain. It is identified as interior. On the other hand, the symmetry plane of the smaller but denser domain is appropriately recognized. Any suggestions as to why this happens and any recommendations on how to fix this? Thank you all in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
changing default unit in Gambit | NISHIKANT TAMRAKAR | FLUENT | 6 | May 20, 2016 01:22 |
mass flow rate on the Iso-clip surface & interior | Sunil Gupta | FLUENT | 0 | April 22, 2008 09:29 |
Fluent default settings | PAD | FLUENT | 0 | June 26, 2006 02:24 |
fluids cross interior face? | jdb | FLUENT | 6 | January 22, 2006 17:22 |
Boundary conditon about interior | zhou | FLUENT | 0 | September 19, 2003 18:00 |