 |
 |
 |
|
|
|
[Sponsors] | ||||
August 16, 2005, 17:12
|
dynamic meshing
|
#1 |
|
Guest
Posts: n/a
|
i am simulating a rotating and translating rigid body in a fluid zone using dynamic mesh. the velocities are constant. the mesh works for a short while if i use a small time step like 10e-3, but after that mesh fails. it is a 3d model. can anyone give me some suggestions as to how i can custom smoothen/remesh it after a few timesteps or something like that so that my dynamic mesh doesnt fail?
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| dynamic meshing | pronik_zoro | ANSYS Meshing & Geometry | 0 | March 12, 2011 11:01 |
| Dynamic meshing | Manoj Kumar | FLUENT | 3 | June 27, 2010 19:26 |
| [GAMBIT] Dynamic Meshing of a combustion chamber | donarundas | ANSYS Meshing & Geometry | 1 | December 2, 2009 07:13 |
| Issues with dynamic meshing | sridhu88 | FLUENT | 1 | June 11, 2009 16:46 |
| dynamic meshing option | arehman | Main CFD Forum | 4 | June 27, 2004 02:55 |
Linear Mode
