Home > Forums > Software User Forums > ANSYS > FLUENT

Postprocessing

Mark Forums Read

Reply

Search this Thread

August 25, 2005, 09:38	Postprocessing	#1
C. Lee Guest Posts: n/a	I am using Airpak to siumulate how concentrations of hydrognen sulfide change in a chamber. Initial condition of the room is unevenly distributed. From the unevenly distributed situation, I wanted to see how the concentrations changes over 20 minutes at several locations in the chamber. When I did steady station mode to see spatial distribution of hydrogne sulfide, it was successfuly shown. However, for the trasient mode, I could not see any changes of the concentrations over time. Would you please help me on this?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
using fieldAverage library to average postprocessing	eelcovv	OpenFOAM Programming & Development	32	May 17, 2022 09:55
How to export the specific heat and viscosity for postprocessing (compressible) ?	david39	OpenFOAM Post-Processing	2	January 4, 2019 07:04
[pythonFlu] Postprocessing using pythonFlu + Matplotlib +Scipy	francois	OpenFOAM Community Contributions	2	June 21, 2011 11:26
Question about Postprocessing Using UDF(in tutoria	sarah_ron2002	FLUENT	1	April 10, 2007 16:17
postprocessing	bas rijkse	FLUENT	0	July 5, 2001 08:30

All times are GMT -4. The time now is 06:05.