|
[Sponsors] |
September 1, 2005, 10:24 |
CUSTOM BOUNDARY CONDITION
|
#1 |
Guest
Posts: n/a
|
DOES ANYBODY KNOWS IF FLUENT SUPPORTS CUSTOM BOUNDARY CONDITION? BY CUSTOM I DON'T MEAN PROFILE B.C.'S BUT NEW TYPE. FOR EXAMPLE U''(X)=0 AT OUTLET???
THANK YOU |
|
September 1, 2005, 16:26 |
Re: CUSTOM BOUNDARY CONDITION
|
#2 |
Guest
Posts: n/a
|
I am also wondering the same thing. Would it be possible to change the outlet from a Pressure Outlet to a wall depending on the time?
|
|
September 2, 2005, 03:11 |
Re: CUSTOM BOUNDARY CONDITION
|
#3 |
Guest
Posts: n/a
|
I have your same problem, but I fear the answer is no...Please let me know if you find an anwer to our probs. Luca
|
|
September 2, 2005, 06:21 |
Re: CUSTOM BOUNDARY CONDITION
|
#4 |
Guest
Posts: n/a
|
That's perfectly possible! If you can do it using "boundary conditions" panel, then you can also do it using macros and "execute commands" panel. There you are able to execute it at any number of time-steps you need (of course you are restricted to equal number of time-steps).
This might be enough for you. Another way I do not know for now. Best wishes, Razvan |
|
September 11, 2005, 21:41 |
Re: CUSTOM BOUNDARY CONDITION
|
#5 |
Guest
Posts: n/a
|
I also have a similar problem! I want to define a constant volumetric flow rate boundary condition for an unsteady gas flow problem (like what you'd have if a vacuum pump was evacuating a chamber). Can I do that??!!
|
|
September 12, 2005, 02:46 |
Re: CUSTOM BOUNDARY CONDITION
|
#6 |
Guest
Posts: n/a
|
Dear Hadley, this can be done quite simply. You should define a mass source. See Fluent documentation. Regards Luca
|
|
September 12, 2005, 17:24 |
Re: CUSTOM BOUNDARY CONDITION
|
#7 |
Guest
Posts: n/a
|
Thanks Luca. I'll try that and see how it goes.
|
|
September 21, 2009, 13:02 |
|
#8 |
New Member
pinho
Join Date: May 2009
Posts: 22
Rep Power: 16 |
Dear Luca...
You said it was quite simple.. but I am not getting the ideia.. How can you simulate a simple case where you want evacuate air from a chamber.. and plotting the pressure over time?? regards jpinho |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 05:05 |
Setting outlet Pressure boundary condition using CAFFA code | Mukund Pondkule | Main CFD Forum | 0 | March 16, 2011 03:23 |
asking for Boundary condition in FLUENT | Destry | FLUENT | 0 | July 27, 2010 00:55 |
How to set boundary condition in Fluent for the fo | Peiyong | FLUENT | 1 | November 10, 2006 11:44 |