|
[Sponsors] |
September 7, 2005, 06:23 |
Gauge of boundary layer
|
#1 |
Guest
Posts: n/a
|
Hi
I hope somebody can help me. I would like to display the gauge of the boundary layer. When "x" is the length, "y" the hight and "z" the width of my cube. The stream lines go along the "x"-parameter. How can I make a plot of the y-z-plane which display the gauge of my boundary layer. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Default Faces on Boundary Layer | axel | OpenFOAM Meshing & Mesh Conversion | 8 | February 17, 2011 07:47 |
[GAMBIT] problems in boundary layer | yubaibai88 | ANSYS Meshing & Geometry | 8 | April 19, 2010 21:07 |
Adapt mesh without modifying boundary layer cells? | Freeman | FLUENT | 0 | February 22, 2009 14:11 |
3D Boundary Layer | Mario | FLUENT | 0 | February 17, 2009 03:40 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |