 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2005, 09:27
|
diesel combustion
|
#1 |
|
Guest
Posts: n/a
|
Hi everybody! I have some problems in simulating a diesel combustion within a cylinder. I used Segregated solver, dynamic mesh, discrete phase (to simulate injection process) and finite rate/eddy dissipation model to symulate diesel combustion. At the end of the process I find somthing like 20% unburned fuel in my combustion chamber. Do you think the problem can be pre-exponential factor, Activation energy and temperature exponent for this reaction? I used the default parameters. Any other suggestion? Thanks everybody in advance
Marco |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Diesel Engine combustion chamber analysis | sachinthakre | FLUENT | 12 | August 13, 2013 15:14 |
| Diesel combustion simulation ( Heat release rate) | venkatesh | Siemens | 2 | April 29, 2009 08:38 |
| Diesel fuel combustion | Marek | CFX | 1 | November 30, 2008 14:39 |
| diesel engine spray and combustion | usker | Siemens | 6 | April 24, 2006 23:36 |
| Can I use Fluent to stimulate diesel combustion | Allanhill | FLUENT | 1 | March 6, 2003 08:46 |
Linear Mode
