Meshing divergent nozzle entry of a long pipe

September 22, 2005, 12:06

I am trying to mesh a geomtery with structured mesh however i am unable to mesh it.

the geometry is a divergent nozzle entry into a long pipe. the divergent entrance also have a smaller pipe attached from above just 100mm before outlet for air entrance.

divergent nozzle (inlet D=150mm and outlet D= 254mm, length = 470mm) long pipe (dia=254mm, length=36000mm) smaller pipe (D= 50.8mm, length = 250mm)

any advice on how to mesh this geomtery will be highly appreciated.

September 25, 2005, 17:07

subdivide your domain

September 22, 2005, 12:06	Meshing divergent nozzle entry of a long pipe	#1
Aly Guest Posts: n/a	I am trying to mesh a geomtery with structured mesh however i am unable to mesh it. the geometry is a divergent nozzle entry into a long pipe. the divergent entrance also have a smaller pipe attached from above just 100mm before outlet for air entrance. divergent nozzle (inlet D=150mm and outlet D= 254mm, length = 470mm) long pipe (dia=254mm, length=36000mm) smaller pipe (D= 50.8mm, length = 250mm) any advice on how to mesh this geomtery will be highly appreciated.

September 25, 2005, 17:07	Re: Meshing divergent nozzle entry of a long pipe	#2
Ahmed Guest Posts: n/a	subdivide your domain

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Meshing a pipe with a hole	leekj92	ANSYS Meshing & Geometry	8	May 19, 2011 13:34
Long pipe	Derek	CFX	11	April 2, 2007 18:18
CFX-mesh for a long pipe	Julian	CFX	4	September 27, 2005 04:19
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 21:31