Turbulence modelling error
Hey guys,
I am a newbie and I was trying to do a turbulence modelling. The flow is inside a large duct and the velocity is very high. I was modeling the 2d case and prepared a udf for inlet velocity, dissipation rate and turbulent kinetic energy as explained in the user guide. As i started the iteration, even before it goes through the first iteration, it gives me this error: turbulent viscosity limited to viscosity ratio of 1.000000e+005 in 341000 cells I tried to change the limit of viscosity ratio to a higher value, but still it gives me a similar error. Any thoughts? Thanks in advance, Derick |
Re: Turbulence modelling error
Common question, just scroll one page down to find this thread
http://www.cfd-online.com/Forum/fluent.cgi?read=31826 And a little forum search will get you alot of good answers like this one from zxaar http://www.cfd-online.com/Forum/flue...cgi?read=28356 RoM |
Re: Turbulence modelling error
Thanks RoM...that helped me and I got it to work
Derick |
All times are GMT -4. The time now is 10:06. |