|
[Sponsors] |
October 6, 2005, 10:08 |
Convergence problems for 2D model
|
#1 |
Guest
Posts: n/a
|
I have two fluids that flow in turbulent counter-flow through rectangular chanels and they are separated by an steel plate. I made the model in Gambit (2D) and I defined the sourfaces between the two fluids and plate like interface. I coupled in Fluent the two pairs of interfaces. The iteration begins without warnings or errors, but the convergence is still far, even after few thousand iterations, especialy for continuity (is about 0.5!!!)! Where is my fault? Thank you!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 06:36 |
Convergence Problems | Carlos | FLUENT | 0 | March 12, 2007 03:44 |
NACA0012 Convergence Problems | StudentAndrew | CFX | 6 | November 21, 2005 07:49 |
VOF model convergence | lana | FLUENT | 11 | October 1, 2005 06:23 |
convergence problems | jeremy | FLUENT | 7 | May 30, 2002 07:41 |