Home > Forums > Software User Forums > ANSYS > FLUENT

about patch

Mark Forums Read

Reply

Search this Thread

October 7, 2005, 08:38	about patch	#1
ZQX Guest Posts: n/a	there are two zones.one is fluid, the other is solid. i want to give them different temperatures. can i patch them? it seems that if i patch one of them, the other will have the same temperature. any suggestion? thanks.

October 14, 2005, 04:54	Re: about patch	#2
ly Guest Posts: n/a	try to define fluid/solid in Gambit when you draw the model

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
CheckMeshbs errors	ivanyao	OpenFOAM Running, Solving & CFD	2	March 11, 2009 02:34
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12

All times are GMT -4. The time now is 06:44.