CFD Online Logo CFD Online URL
Home > Forums > FLUENT

solid-solid interface

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   October 11, 2005, 10:16
Default solid-solid interface
Posts: n/a
Hi all,

i am having problems with my mesh. I am modelling an aerofoil in transonic flow. What i have is an aerofoil(solid zone) and an additional piece of mesh attached to it (also solid zone). However the attached piece of mesh is not conected along its entire length, sort of,


|addtional bit|

| |-------| |

| | | |


| |

| what would be the aerofoil |


but when i solve the flow the solution diverges due to the energy. i have tried labelling each part individual as a wall so that i have coupled heat transfer but this does not work! any ideas?

Many thanks,


p.s. if the aerofoil and additional mesh is combined into one solid zone the solution will converge.

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 45 February 8, 2016 05:42
RPM in Wind Turbine Pankaj CFX 9 November 23, 2009 05:05
Convective Heat Transfer - Heat Exchanger Mark CFX 6 November 15, 2004 16:55
Replace periodic by inlet-outlet pair lego CFX 3 November 5, 2002 21:09
CFX4.3 -build analysis form Chie Min CFX 5 July 12, 2001 23:19

All times are GMT -4. The time now is 14:42.