|
[Sponsors] |
October 12, 2005, 16:39 |
refreshing contours after x iteration
|
#1 |
Guest
Posts: n/a
|
Hi again,
How do I refresh the contours monitor after x iteration during iterations? |
|
October 13, 2005, 02:58 |
Re: refreshing contours after x iteration
|
#2 |
Guest
Posts: n/a
|
You can use the Solve->Execute command panel to update a contour plot. Define 2 commands the first is
//dis/setw X It will activate the window number X (where your contour plot is) Second command is //dis/cont temperature to display a temperature contour. RoM |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 02:54 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 04:23 |
Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 23:30 |
Creating, loop or iteration using expression edito | Jan | CFX | 3 | July 28, 2003 12:01 |
Heat exchanger problem | chiseung | FLUENT | 16 | October 20, 2001 05:36 |