|
[Sponsors] |
October 17, 2005, 05:32 |
fluent warning: SIGHUP signal
|
#1 |
Guest
Posts: n/a
|
Hi
while running a simulation fluent gave me a warning: 'received SIGHUP signal' what is this...does it has any significance thanks in advance |
|
October 17, 2005, 20:48 |
Re: fluent warning: SIGHUP signal
|
#2 |
Guest
Posts: n/a
|
One reason for that:
You must have closed or exited the terminal from which you started fluent. Usually not a problem. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 05:20 |
[swak4Foam] installing funkySetFields | prapanj | OpenFOAM Community Contributions | 65 | October 8, 2015 18:46 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 16:45 |
OF14 compilation error bistreamb is already declared in this scope | rafal | OpenFOAM Installation | 5 | August 26, 2008 12:23 |
IcoLagrangianFoam_problem | zhoubinwx | OpenFOAM Bugs | 2 | May 21, 2008 05:55 |