 |
 |
 |
|
|
|
[Sponsors] | ||||
October 28, 2005, 07:13
|
Grid Direction
|
#1 |
|
Guest
Posts: n/a
|
I am relatively new to CFD.I want to use 3D mesh for some computational work on Wind turbines. If I have to sacrifice some grid points to reduce the run-time, which direction should I choose to coarsen the grid without affecting much of the final output ? Usually which directions are more important to be fine-meshed than the other ? Thanks a lot for your help.
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MapFields to New Grid For Extreme Grid Deformations due to Body Motion | albcem | OpenFOAM | 0 | May 5, 2009 14:17 |
| Obtain Geometry Data from a Grid File in CFX 10.0 | ARJUN | CFX | 2 | August 17, 2006 07:20 |
| Grid refinement. | Sas | Main CFD Forum | 8 | September 2, 2005 08:36 |
| Loading transient data of moving grid | leo | Siemens | 3 | April 9, 2003 01:35 |
| Numerical methods for discontinuous grid interfaces? | Hansong Hang | Main CFD Forum | 12 | September 16, 1998 22:26 |
Linear Mode
