 |
 |
 |
|
|
|
[Sponsors] | ||||
October 30, 2005, 09:34
|
how to display recirculation zone?
|
#1 |
|
Guest
Posts: n/a
|
For swirling burner,there will exist recirculation zone. But I have a problem: how to display the size and length of recirculation zone in FLUENT? Thank you!
|
|
|
||
|
October 31, 2005, 02:32
|
Re: how to display recirculation zone?
|
#2 |
|
Guest
Posts: n/a
|
I usually plot the iso-contour of 0 axial velocity.
Regards, Robert |
|
|
|
||
|
October 31, 2005, 07:39
|
Re: how to display recirculation zone?
|
#3 |
|
Guest
Posts: n/a
|
Thanks for your reply! But if I want to know the exact dimension of the recirculation zone, what should I do? Regards,Judy
|
|
|
|
||
|
November 5, 2005, 21:33
|
Re: how to display recirculation zone?
|
#4 |
|
Guest
Posts: n/a
|
what's the meaning of 0 axial velocity? there are three velocities in the x,y,z directions repectively. which one should I choose?
thank you? |
|
|
|
||
|
November 14, 2005, 09:58
|
Re: how to display recirculation zone?
|
#5 |
|
Guest
Posts: n/a
|
I meant the velocity component which is parallel to the symmetry axis of the burner (i.e. U if the symmetry axis is 0x).
|
|
|
|
||
|
November 14, 2005, 10:12
|
Re: how to display recirculation zone?
|
#6 |
|
Guest
Posts: n/a
|
I would extract the 0-isosurface (Surface->Iso-Surface) and then in Report->Surface Integrals you can check the dimensions of the surface. Regards, Robert
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
| Plotting recirculation zone in CFD Post | ashtonJ | CFX | 0 | April 30, 2011 20:31 |
| Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
| Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
| Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |
Linear Mode
