 |
 |
 |
|
|
|
[Sponsors] | ||||
October 31, 2005, 03:20
|
UDF macros and updated mesh geometry
|
#1 |
|
Guest
Posts: n/a
|
Hi all, I'm writing an udf for mesh updating (a fsi problem with large rotations) and just wanted to check if for example F_AREA() macro works based on the original or updated mesh geometry. Any comment is greatly appreciated. Maziar
|
|
|
||
|
November 1, 2005, 07:29
|
Re: UDF macros and updated mesh geometry
|
#2 |
|
Guest
Posts: n/a
|
It works on the updated geometry. The old geometry is not kept.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| udf | DAE | FLUENT | 1 | May 20, 2003 13:29 |
Linear Mode
